Perhaps if these devices could ping the router and interent once every couple hours once they go into Local Only mode this would resolve? To be fair, I've not yet tried the resent suggestion if using a guest newtwork for the devices, because if this my ISPs Auto DNS settings are causing the issue, then the guest network wouldn't help.Īlso, one of my H300 strips randomly, shows one or two plugs as local only while the rest are fine.Seems to me as though there is a software glitch somewhere. I've done all the suggestions here so far, including reserving the addresses for each one in my DHCP server. I reset them to factory defaults and they come right back up.however, they don't seem to be the same plugs each time. Could this be causing issues for the plugs? I say this only becuase, my plugs seem to randomly chose to go local only about once a week, but only a few do this. This includes a primary DNS of my ISP in IPV4 and the secondary using IPV6. That said, I've left the public side of my Router running both IPV4 and IPV6. Eventually I plan to switch over to a new device for the OpenVPN server for my external clients accessing internal network resources, I just haven't gotten around to it. However, internally, I've shut off IPV6 becasue of one device I have internally (an older OpenVPN server) has issues when running on a network where both IPV4 and IPV6 are available. My router uses both IP4 and IP6 addresses (one each) from my ISP on the public side of my router. One of the strips does appear more resiliant than the other, but they are running the same firmware, associate with the same SSID, thinking outside of the box. With the network running normally, if I unplug the stips from the wall and then re-plug them, once they boot, the Local Only goes away until the next power glitch. Multiple APs all centrally managed with the same config and roaming enabled (I work for a very large networking company), however when the power cicles, none will be available for the duration of their boot time, which is likely longer than the Kasa strips. Things to consider in my setup - I am running commercial, not consumer, wireless. I suspect the same may be true if I was to reboot my access points, but have not tried it yet. does not appear to periodically retry to associate. It then does not recover from that state, e.g. What I am seeing is if there is a power failure (whole home) when the power returns the Kasa strip is failing to reassociate to the access points, as they are still booting. I don't see any issues with DNS or NTP OTA and I continue to run IPv4 on the SSID the strips connect to.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |